retransmit

retransmit是一個英語單詞，主要用作動詞。作及物動詞時意為“轉播；中繼；重新傳送”等。

基本介紹

• 外文名：retransmit
• 詞性：及物動詞
• 發音：[ˌritrænsˈmɪt] 

單詞釋義

英 [ˌriːtrænzˈmɪt; -trɑːnz-; -ns-] 美 [ˌritrænsˈmɪt]

vt. 轉播；中繼；重新傳送

[ 第三人稱單數 retransmits 現在分詞 retransmitting 過去式 retransmitted 過去分詞 retransmitted ]

短語搭配

fast retransmit 快速重傳

report retransmit 報務轉發

retransmit-overtime 逾時重傳

two-route retransmit 雙路轉發

Split Fast Retransmit 分集快速重傳

RTO Retransmit TimeOut 中繼傳送逾時

雙語例句

• Fast-retransmit phase is turned on for a connection. 對於某個連線，打開了快速重新傳輸階段。
• This timer is used to determine the retransmit interval. 這隻計時器用來決定重送間隔。
• There we just created another packet if we needed to retransmit . 之前我們在需要重傳時創建新的包。
• The new algorithm, split fast retransmit, is the key of SCTP load sharing. 分集快速重傳算法是實現負荷分擔的關鍵。
• Played back via a speaker using a similar needle unit, the device could retransmit the sounds. 通過使用類似針狀裝置的揚聲器進行回放，就可以將聲音還原了。
• They then retransmit packets from the source segment to the destination segment when necessary. 之後在必要時，網橋將源網段的數據包重傳送到終網段。
• Requests earnestly each everybody to retransmit positively, lets more people know this matter! 請大家認真對每一個積極轉發，讓更多的人知道這件事！
• This device includes a Retransmit from MARK feature that utilizes two control inputs, MARK and RT. 該器件包括一個從馬克的功能，利用兩個控制輸入，標記和RT重傳。
• The invention also discloses a data retransmit method, sender, receiver and data transmission system. 本發明還公開數據重傳方法、傳送機、接收機和數據傳輸系統。
• Retransmission timer expires for a connection for the first time or the fast retransmit phase is turned on. 連線的重新傳輸計時器首次計時到期，或者打開了快速重新傳輸階段。
• Network data loss resulting in retransmit: Often, a system tries to achieve 'at most once' transmission tries. 網路數據丟失需要重傳：一般地，系統最多只嘗試重傳一次。
• This scheme includes four phases which are Slow Start, Congestion Avoidance, Fast Retransmit and Fast Recovery. 該模型包含慢啟動、擁塞避免、快速重傳和快速恢復四個階段。
• The sender eventually will time out and retransmit all unacknowledged frames, beginning with the lost or damaged one. 最後發方將會不計時，並且由丟失的或損壞的一幀開始，重發所有未接收的幀。
• Thus, a system may accept data and then retransmit it back out of the system. This is known as the reflection problem. 因此，系統有可能接受惡意資料後再將資料回傳到原系統，我們稱之為反射性問題。
• Upon a need to retransmit, data is sent to all addresses in an attempt to improve the probability of reaching the other endpoint. 當需要重傳時，數據會傳送到所有的地址，以增加到達另一個端點的可能性。
• The infrastructure USES an exponential back-off algorithm to determine when to retransmit, based on a computed average round-trip time. 基礎結構會使用指數倒退演算法，根據計算出來的平均來回時間決定何時重新傳輸。
• This limitation can be overcome by "Repeaters," which pick up weak signals, amplify them, and retransmit them on a different frequency. 這種限制可以被中繼站所克服。中繼站可以捕捉到微弱的信號，然後把它放大，再用不同的頻率重新傳送。
• This extra information helps the sender determine that the losses are fairly minimal and that it only needs to retransmit a little bit of data. 這種附加信息可以幫助傳送方確定丟失的包最少，只需重新傳送很少的數據。
• Correcting these dropped packets requires the transmitter to first recognize that the packet was not acknowledged, and then retransmit that packet. 要糾正這種丟失現象，首先需要傳送端知道到傳送包後並沒有得到應答，然後重新傳送這個包。
• The problem with that is that if a fragment never arrives, there is nothing at the IP level that will cause a retransmit, so the entire datagram is lost. 的問題是，如果一個片段從未到達，沒有IP水平將導致一個中繼，所以整個數據報丟失。
• Without this extra information, it would need to retransmit much more data and slow down its sending rate to accommodate what looks like a high-loss network. 如果沒有這種附加信息，它需要重新傳送大量的數據，這樣會降低傳送速率，從而適應高丟包率的網路。
• The average size of the retransmit queue can be calculated from the packets scanned counter if the number of SACK options sent is also tracked at the client. 如果在客戶機可以跟蹤發出的SACK選項的數目，則重傳佇列的大小可從掃描包計數器中計算得到。
• In order to provide reliable data transmission service on disturbed channels, a modified Go-Back-N ARQ protocol is used to retransmit data by a communication gateway. 文中介紹為了在有擾信道中提供可靠數據傳輸服務，通信網關在套用層使用經過改良的連續ARQ協定機制實現數據重傳。
• In order to alleviate the long retransmission intervals brought by long propagation delays, bulk retransmissions are introduced to retransmit the lost packets in time. 為了克服由大時延帶來的重傳時間間隔過大的缺點，採用了批量重傳來及時重傳丟失的報文段；
• One attack node catches the routing packet in network and then transmits it to colluding node through "Tunnel". Colluding node retransmit the packet into the network directly. 攻擊節點捕獲網路中正常路由分組，通過“隧道”將其傳輸給另一端合謀節點，合謀節點再將該分組重放到網路中。
• Transmits partially the communications channel which provides by China mobile with the aid of the GPRS wireless grouping exchange technology, realizes the data transparently to retransmit. 傳輸部分由中國移動提供的通信信道藉助GPRS無線分組交換技術，實現數據透明轉發。